Copyright © 2021 CATEYE Co., Ltd.

CATEYE PADRONE SMART +

Setup Flowchart

2. Checking package contents

3. Install Cateye Cycling™

4. Pairing a smart computer with a smartphone

5. Pairing a sensor or a Shimano DI2 system with a smartphone (If you have sensors or a DI2 system)

6. Mounting the bracket

The bracket can be mounted on either the stem or the handlebar.

Watch video

 

Bracket

Bracket band

See illustrations

When mounting on the stem

When mounting on the handlebar

Mounting and removing the smart computer unit

● When mounting on the stem

1. Check bracket orientation and attach it to the bracket band.

2. Remove the seal from the bracket rubber pad and stick the bracket rubber pad onto the bracket band.

Bracket rubber pad

3. Loop the bracket band around the stem and tighten the dial to secure it.

Dial

Cut

Caution

• Always tighten the dial by hand.
Using a tool or other object to tighten the dial may crush the screw thread.

• Trim bracket band carefully so the cut end will not cause injury (see step 3 above).

● When mounting on the handlebar

1. Check bracket orientation and attach it to the bracket band.

Bracket band

Bracket

2. Remove the seal from the bracket rubber pad and stick the bracket rubber pad onto the bracket band.

Bracket rubber pad

3. Loop the bracket band around the handlebar and tighten the dial to secure it.

Dial

Cut

Caution

• Always tighten the dial by hand.
Using a tool or other object to tighten the dial may crush the screw thread.

• Trim bracket band carefully so the cut end will not cause injury (see step 3 above).

● Mounting and removing the smart computer unit

Mounting

Click

Removing

While holding smart computer

Push out

Caution

To remove smart computer, push out while holding the unit with the other hand to ensure that it does not fall.

7. Mounting the speed (cadence) sensor (ISC-12)

(Optional)

8. Wearing the heart rate sensor (HR-12)

(Optional)

Usage Instructions