Changing ANT+ sensor tire circumference

This section describes how to change the tire circumference for a paired ANT+ sensor.

The ANT+ sensor tire circumference setting can be changed on the AVVENTURA.

* The same procedure is used to change settings for a Bluetooth® sensor.

Important

Set the tire circumference for each sensor capable of speed measurement. The initial value is 2,096 mm (700x23c).

AVVENTURA

1. If the AVVENTURA is turned off, press and hold (POWER) for 1 second to turn it on.

2. Press OPTION to switch to the option screen.

GPS searching

Option screen

3. Press MODE to select [Device], and press SS to apply the selection and display the Device screen.

Option screen

Device screen

4. Follow the same procedure and select [Device Setup] > (Target Sensor) to change the tire circumference.

Device screen

Switch item

Enter

Device Setup

Sensor selection

Enter

Entering the tire circumference

Move digit

Increase value

Enter

Enter the tire circumference (the length of the outer circumference of the tire) in mm for the tire on which the sensor is installed. (Setting range: 0100 to 3999 mm)

* “Error” is displayed if a value outside the setting range is entered.

Determining tire circumference

5. Press OPTION to confirm the settings and to return to the measurement screen.

Configuration of the sensor settings is now complete.