3. Pairing an Bluetooth® sensor
(for users with Bluetooth® sensors)
This section describes how to pair Bluetooth®-compatible sensors.
Important
• Pair all of the sensors to be used.
• Do not pair sensors at a race venue or in similar locations where there are a lot of other users. Doing so may cause the sensors to be paired with another device.
• When using third-party Bluetooth® sensors
Third party Bluetooth® sensor pairing information will not be transferred to the AVVENTURA. Pair using the method for pairing an ANT+ sensor.
AVVENTURA
1. Press and hold 
(POWER) on the AVVENTURA for 1 second to turn off the power.
Important
Cateye Cycling™ will not be able to detect a Bluetooth® sensor while the AVVENTURA is connected to the smartphone (Cateye Cycling™). Turn off the AVVENTURA before pairing a Bluetooth® sensor.
Smartphone
2. From the Device screen, tap [Pair to Device].
Activate the sensor.
* For the CATEYE sensor signal activation procedure, refer to the sensor’s online manual.
Tap [Pairing] to search for pairable sensors.
When Cateye Cycling™ detects the sensor signal, a message is displayed on the smartphone.
Tap [Pairing] to complete pairing of the displayed sensor.
* If the device name is different than expected, tap [Skip], and then tap [Pairing] again.
Repeat until the desired device is displayed.
* When pairing a sensor with Cateye Cycling™, an “A” is displayed after the sensor name.
* To pair another Bluetooth® sensor, repeat the same procedure again.
* Up to 18 separate sensor IDs—including the computer—can be paired.
3. Set the tire circumference for a sensor capable of speed measurement.
Tap [Device], and then tap [Sensor name] > [Tire Circumference] (the length of the outer circumference of the tire).
* Sensors incapable of measuring speed are not displayed.
Scroll to find the tire size indicated on the sidewall of the tire. Tap and hold to choose the tire size.
* Initial value: 2096 mm (700x23c)
* Set the tire circumference for each sensor capable of speed measurement.
* You can also change the device name and delete pairing from this screen.
Important
Changes are transferred when connecting the AVVENTURA to the smartphone (Cateye Cycling™).
Bluetooth® sensor pairing is now complete.
* Once pairing is complete, mount the sensors on your bicycle or body according to the individual sensor’s instruction manual.
For more details on mounting/using the CATEYE sensor, refer to the sensor’s online manual.
Important
Data for cadence, heart rate, and power is not be displayed under the initial configuration of the AVVENTURA measurement screen.
Customize the measurement screen to display measured values from paired sensors.
• If you have ANT+ sensors:
Proceed to “4. Pairing an ANT+ sensor”.
• For users without a sensor:
Proceed to “5. Mounting the bracket, and attaching/removing the AVVENTURA”.
Copyright © 2020 CATEYE Co., Ltd.