2. Pairing (ISC-12)

ISC-12

1. Before use

2. Pairing

Important

This section explains how to pair the smart computer and the sensor using the “Cateye Cycling™” smartphone app.

To pair the sensor directly to the computer without a smartphone, refer to your computer’s online manual or instruction manual.

The Cateye Cycling™ smartphone app (free) must be installed on the smartphone to be used in advance.

* For the latest information on the smartphones that are compatible with Cateye Cycling™ operations, see “Cateye Cycling™ Recommended Devices”.

Smartphone

1. From the startup screen, tap [Start] and begin pairing.

* If the startup screen does not appear, tap (Startup) at the top left of the screen to display it.

2. Move the magnet through the sensor zone several times to transmit the signal. (Within 3 mm)

Sensor zone

Magnet

When Cateye Cycling™ detects the sensor signal, a message will be displayed on the smartphone.

Tap [Pair to Device]. The verified sensor (CATEYE ISC-12) is displayed under [Device] and pairing is completed.

* When pairing a sensor with the Cateye Cycling™ app an “A” is displayed after the sensor name (ISC).

3. Set the tire circumference to the sensor.

Select the tire circumference according to the tire size written on the side of the tire.

* Default value: 2096 mm (700x23c)

* Requires to set tire circumference for each sensor.

Sensor pairing is now complete.

* If you want to pair another sensor, repeat the same procedure again.

* You can also change sensor names and cancel pairing from this screen.

Note

• When using the smart computer in Sensor Direct Mode:

Connect the smart computer to Cateye Cycling™, and then transmit the paired sensor information.

• When using PADRONE SMART+:

Cadence will not be displayed on the measurement screen in default configuration.

Customize the measurement screen to display cadence measurements.

3. How to install the unit on your bicycle