​

1. Verify that [Connect] is set to ON in the (MENU), and then tap [Device].

Tap [Pair to Device] to start pairing.

 

​

2. Activate the sensor or the DI2 system.

​ Activating the sensor or the DI2 system

When Cateye Cycling™ detects the signal from the sensor or the DI2 system, a message is displayed on the smartphone.

Tap [Pair]. The synchronized sensor is displayed on the [Device] screen and pairing is completed.

* When pairing a sensor or a DI2 system with Cateye Cycling™, an "A" is displayed after the sensor name.

* If you have paired a sensor capable of speed measurement, proceed to step 3.

 

​

3. Set the tire circumference for a sensor capable of speed measurement.

* If you have not paired a sensor capable of speed measurement, this step is not required.

Tap [Device], and then tap [Sensor name] > [Tire Circumference] (the length of the outer circumference of the tire).

Select the tire circumference according to the tire size written on the side of the tire.

​ Determining tire circumference

* Default value: 2096 mm (700x23c)

* Requires to set tire circumference for each sensor.

* You can also change device names and cancel pairing from this screen.

 

​

4. Set the DI2 system switch control and gear information.

* If you have not paired a DI2 system, this step is not required.

Tap [Device], and then tap [DI2].

Change the DI2 system settings as necessary.

​

• Switch Configuration
Uses the DI2 system switch to operate a smart computer.
​ Changing the switch settings

• Gear Information
Select [Number of Teeth] or [Gear Ratio] for the gear information displayed on the measurement screen.

• Synchro Shift Mode Display
You can display the synchro mode on the measurement screen.

* When you turn on synchro shift mode, the incoming notification icon is not displayed.

* You can also change device names and cancel pairing from this screen.

 

Sensor pairing is now complete.

* If you want to pair another sensor, repeat the same procedure again.