Pairing-App

Pairing

Important

• Pairing (sensor ID synchronization) must be performed in order to use smart computer and sensors.

• Do not pair sensors at a race venue or in similar locations where there are a lot of other users. Doing so may cause smart computer to be paired with another device.

Smartphone

1. From (MENU) at the top left of the screen, turn on [Connect], and then tap [Device].

Tap [Pair to Device] to start pairing.

For instructions on using devices, refer to the following:

Pairing with smart computer
Smart computer

1. On the measurement screen, press MODE for 1 second to display the smartphone search screen.
Smartphone search
screen
Smartphone
When Cateye Cycling™ detects smart computer, a message is displayed on the smartphone.

Tap [Pairing] to complete pairing.

* If you are using Padrone Smart with an iPhone, the following message may be displayed.

If this message is displayed, tap [Pair] again.
After pairing is completed, from (MENU) at the top left of the screen, tap [Trip] to switch to the Trip screen.
Smart computer
When the smartphone switches to the Trip screen, smart computer switches from the smartphone search screen to the [ready] (measurement standby) display.
Smartphone search
screen
Measurement standby
Smart computer pairing is now complete.
* If you have other sensors, continue pairing them.

Pairing with a sensor
Smart computer can be used with sensors compatible with Bluetooth. Pair it with optional accessories or commercial sensors as required.
Important
• Pair all sensors that you intend to use. If you want to pair another sensor, repeat the same procedure again.
• When using an iPhone, you cannot sync settings of commercial sensors.
When measuring in Sensor Direct Mode, it is necessary to configure sensor settings separately via smart computer.
1. Switching to Sensor Direct Mode
2. Pairing (Sensor ID synchronization)
3. Tire circumference setting

1. Activate the sensor.
Activating the sensor
When Cateye Cycling™ detects the sensor signal, a message is displayed on the smartphone.
Tap [Pair]. The synchronized sensor is displayed on the [Device] screen and pairing is completed.
* When pairing a sensor with Cateye Cycling™, an "A" is displayed after the sensor name.
* If you have paired a sensor capable of speed measurement, proceed to step 2.
Smartphone
2. Enter the tire circumference.
From the [Device] screen, tap the added sensor and select a tire circumference (the length of the outer circumference of the tire).
Determining tire circumference
* Default value: 2,096 mm (700x23c)
* Set tire circumference for each sensor.
* You can also change sensor names and cancel pairing from this screen.
Sensor pairing is now complete.
* Pair all sensors that you intend to use.
If you want to pair another sensor, repeat the same procedure again.