Sensor trouble
No sensor signal is being received
Are the sensors paired?
Pairing must be performed in order to use a sensor.
Is the sensor battery flat?
• Replace the battery with a new one.
* For details on replacing CATEYE sensor batteries, refer to the sensor’s online manual.
Important
If using a Bluetooth® sensor (speed, cadence, heart rate), the measurements related to the sensor's battery replacement period start flashing to indicate that it is time to replace the battery.
Is the magnet in the correct position relative to the sensor?
• Read the sensor’s instruction manual and attach the sensor correctly.
* When using a CATEYE sensor, refer to the sensor’s online manual for installation instructions.
Are you also using a smartphone application that is connecting to the Bluetooth® sensor?
• The Bluetooth® sensor may be connected to the smartphone. Bluetooth® sensors are only able to connect with a single device at a time. Stop using all apps (including Cateye Cycling™) or change the app settings to prevent connection to a Bluetooth® sensor.
Pairing of sensors is not possible
Has the maximum number of allowable sensors been paired?
The following message is displayed when attempting to pair.
The maximum number of sensors (18 IDs) has been paired. In such cases, follow the procedure below to remove any unnecessary paired sensors and perform pairing again.
On the smartphone (Cateye Cycling™)
From
(Menu), tap [Device] > [Delete Sensor] > [Delete].The selected sensor will be unpaired and removed from the device screen.
On the AVVENTURA
All paired sensors can be removed together at once.
1. When “GPS Searching” or “Ready” is displayed, press OPTION to switch to the option screen.
GPS searching
Ready
Option screen
2. Press MODE to select [Device], and press SS to apply the selection and display the Device screen.
Option screen
Device screen
3. From the device screen, press MODE to select [Disconnect Device], and press SS to apply the selection.
Device screen
Disconnect Device
4. Press SS again to delete all paired sensors.
Delete
Pair all necessary sensors again.
Copyright © 2020 CATEYE Co., Ltd.